Kreatos ICHOREX Grease

The stay-put half of the ICHOREX pair. A synthetic grease carrying lubricant-grade PTFE, built for the parts that need a load-bearing film that clings and stays. It will not run, drip or fling off, even under speed, so it keeps protecting through long service intervals.

What it is

A synthetic PAO base enhanced with lubricant-grade PTFE that bonds to the surface, cuts friction and reduces stick-slip. It lays down a load-bearing film on bearings, lead screws, gears and loaded joints that stays put. Where the oil reaches into tight spots and reapplies easily, the grease clings and stays. Near-white, translucent and water-repellent, it suits visible mechanical areas where low staining and tidy application matter.

Lubricate once, leave it

This is the partner for the parts you would rather not keep topping up. The inorganic thickener gives it broad temperature capability with no drop point, so it holds up in enclosed or warm printer environments. It helps reduce stick-slip, wear and operating noise across long service intervals. Apply sparingly to clean surfaces and remove old lubricant before re-greasing.

Best for

• Lead screws and Z-axis screws
• Linear guides and smooth rods
• Bearings, light gears, shafts and splines
• Carriage mechanisms and loaded joints
• 3D printer and small robot motion components
• Any contact you would rather lubricate once and leave

What it does well

• Synthetic PAO base with PTFE for smooth, low-friction motion
• Clings and stays put without running, dripping or flinging off
• Good water repellency and clean near-white appearance
• Broad operating temperature range for enclosed or warm printers
• Helps reduce stick-slip, wear and operating noise
• Long-term lubrication across extended service intervals